Diesly Diesel Fuel Filter Set, Fits RAM 6.7 Cummins Fuel Filter | For 2013-2018 2500-5500 | Includes fuel water separator | Replaces 68157291AA and 68197867AA
Compatibility Note
This product is only designed to be used in Cummins 6.7L 2013-2018 systems.
Product Highlights
Have a Question About this Product?
Reach out to us by chat or email!
- Seat It, Prime It, Start Clean: A clean start after the change depends on two steps the owner's manual and 6.7L Cummins service guides call out. The engine standpipe is oval, so turn the new cartridge until it drops all the way down onto it before the lid goes on. Install the fuel filters dry and never pre-fill a housing, then cycle the key to RUN and back as your owner's manual describes so the lift pump fills the system before you crank. Set the new filters beside the old ones first, so each one goes into the housing it belongs in.
- Made For 2013-2018 RAM 6.7L Trucks: Every filter in this kit is listed for 2013-2018 RAM 2500, 3500, 4500 and 5500 trucks with the 6.7L Cummins, so you are not sorting through parts meant for other years or engines. The engine fuel filter replaces 68157291AA and 68065608AA and the frame-mounted water separator replaces 68197867AA. Check each number against the part you are taking off before you start, and keep the old filters until the truck has started and run normally.
- Both Fuel Filters, One Box: The two filters the fuel service calls for come together, so the job gets finished in one session instead of stalling on the one filter you forgot to order. Inside are the fuel filters 6.7 cummins owners change at every fuel service, the engine-mounted cartridge and the frame-mounted water separator, each with the O-ring it needs. Changing them as a pair keeps both stages on the same schedule, so a fresh filter never sits behind a loaded one.
- Protect The Pump And Injectors: The parts a clogged or wet fuel supply wears out first are the most expensive on the truck, from the high-pressure pump to the injectors, and repairing them is one of the largest bills a diesel owner can face. Two filters stand between the tank and that pump, and changing both on schedule keeps them doing their job. That matters most when the truck works hard, towing a camper or running all day at a job site, because that is when a breakdown costs you the most.
- Good For 15,000 Miles: Change the fuel filter and water separator together every 15,000 miles or 12 months, and reset the fuel filter life reminder in the dash afterward so the next change comes up on time. Following that schedule is the simplest way to keep fuel clean for the long haul, and a kit on the shelf means the next fuel filter replacement is ready the day the reminder comes up. Towing, long idling and dusty roads can call for shorter intervals, so follow your owner's manual for severe service.
Made For The 2013-2018 Fuel System
From the 2013 model year, the 6.7L Cummins in a RAM 2500 through 5500 runs two fuel filters instead of one, so a filter set made for an earlier truck leaves the frame filter out. This diesel fuel filter water separator kit is built for that 2013-2018 layout. The engine filter sits in its housing on the driver side of the engine block, just below the brake fluid reservoir, and the diesel fuel water separator filter mounts on the frame rail between the fuel tank and the engine. Every year in the range takes the same fuel filters, so the 2018 ram 3500 diesel fuel filters in this box are the same ones a 2013 2500 uses. The separator is the first stage, taking out water and coarse debris so it never reaches the engine, and the cummins 6.7 fuel filter on the engine is the fine stage, catching the smaller particles just before fuel reaches the high-pressure pump.
Doing The Change Yourself
Changing a diesel truck fuel filter at home takes basic hand tools and a drain pan, and the filters and O-rings come in this ram 6.7 filter kit. Remove the engine housing lid with a socket or strap wrench, turning it counterclockwise, and lift out the old cartridge. Fit the new O-ring from the kit into the groove in the housing, lubricated with clean engine oil as your owner's manual describes, rather than reusing the old one. Tighten the lid to the torque in your owner's manual and do not overtighten it. The frame filter is changed from under the truck at the frame rail, and the new element presses into its cap. With both fuel filters in and the system primed, start the engine and check both housings for leaks before you drive.
Water In The Fuel And What To Do About It
Water gets into diesel from tank condensation and from poor-quality fuel, and the frame-mounted separator is where it is stopped and collected. When the dash shows the water in fuel message, drain the separator promptly instead of waiting for the next service: set a container underneath, open the drain valve counterclockwise as your owner's manual describes, let it run until clean fuel comes out, then close the valve. Clean diesel looks clear with a blue or green tint, so cloudy fuel or a layer of water in the container means the tank deserves a closer look. When the fuel filter service required message comes up, replace the water separator fuel filter and the engine filter promptly, whatever the mileage.
All products ship same business day if ordered before 2PM Eastern Time. With shipping times, most orders will be delivered within 3-4 days.
All orders are eligible for return within 30 days of delivery. Please note that most of the products we ship are considered Hazardous Materials, or HAZMAT, and will incur a return charge due to additional handling and safety requirements. Please refer to our return policy for full information on returning products back to us.
